Product Alternatives: Advion Ant Gel Bait, Maxforce Fleet Ant Bait Gel
EPA Registration No.: 100-1260
Active Ingredient: Thiamethoxam – 0.01%
Optigard Ant Gel Bait is designed for the control of ants: excluding fire, harvester and Pharaoh ants. Attractiveness of the bait to ants is enhanced by its high moisture retention properties and the bait will remain attractive for at least two weeks following bait deployment. This bait takes advantage of ant trophallaxis (regurgitation) allowing for transfer of
active ingredient throughout the colony. Ants that feed on the gel will return to their nest and transfer the bait to the queen and their young, thereby killing the queen, the young and the entire colony. Dead ants should begin to appear within days after ants have begun feeding on the bait. Substantial reduction in ants foraging should be seen within a few days to a week. For effective management of certain ant species such as Argentine ant, reduction of food sources (such as honeydew-producing insects like aphids) near entry points around the structure is critical. Long term control is most effectively obtained with a combination of methods for ant management.
Directions For Use:
Apply using the syringe applicator or a bait injector. Apply bait in cracks, crevices, corners and out-of-theway places, such as under and behind kitchen appliances and baseboards, under sinks, around window and door frames, pipes and water heater and in the attic, crawl space and garage. Place multiple application spots of gel where ants are observed actively
foraging or entering the structure. If the area to be treated has been recently treated with insecticide, thoroughly clean the area before applying this bait. Do not spray insecticide over gel as this may cause the bait to become repellent. Do not apply to areas that are routinely washed (such as countertops) as bait may be removed or diluted and spread onto the surface.
Visually inspect for the presence of ants and place this product in areas where ants are seen. Optimal locations for bait placement are the active points of entry and areas with potential high moisture including: wall voids, cracks and crevices in kitchens and bathrooms, under sinks, window sills and door frames, screen vents, attics, crawl spaces and garages. In areas of excessive foraging activity, place bait in several locations near the point of entry. Do not place bait in areas that are routinely washed, as washing will remove or dilute bait. Do not treat food preparation surfaces. During follow-up visits inspect placements and reapply as needed.
Place bait on, into or adjacent to structures where ants are observed, adjacent to ant trails and to areas suspected of ant activity. Optimal locations for bait placement are points of entry into the structure and areas with potential periods of high moisture such as: soffits, eaves, weep holes, and where pipes and wires enter the structure. Exposure to direct sunlight, extreme heat or cold and water may reduce length of bait effectiveness. Bait may also be placed outdoors into refillable tamper-resistant bait stations. Close tamper-resistant stations securely after application. During follow-up visits inspect placements and reapply as needed.
Not Labeled For Control Of: Fire Ants, Harvester Ants and Pharoah Ants